3. Bias mini WiFi button OFF by default

Bias mini WiFi button OFF by default


  • Hi, is it possible to make Wi-FI button at the back of my Bias mini to stop flashing every time I boot it? Like turning it off by default until I require it

    0 1 Reply
  • Moderator

    @journeymanmw It's used for Bluetooth connection and will only stop when connected to an iOS device via Bluetooth.

    0 1 Reply

  • @felix said in Bias mini WiFi button OFF by default:

    @journeymanmw It's used for Bluetooth connection and will only stop when connected to an iOS device via Bluetooth.

    I'm sorry Felix, but you're not really answering the question... It's not about WiFi or bluetooth, it's about the anoying blinking.
    I asked myself the same. As I don't use bluetooth at all (because I don't have an iOS device), I have to turn off the blinking button each time I turn on the amp...

    But now, as I'm a little familiar with the PG support, I don't expect any further development of my amp...

    0

  • Reset from BIAS MINI:

    1. Make sure the power is off.
    2. Hold the Wireless Button on the back panel, and turn the power On, hold it until it starts flashing.
    3. Once the Wireless Button begins to flash, hold it again until it stops flashing. This will allow it to factory-reset.
    4. If at any point you decide not to factory-reset after holding the Wireless Button, simply tap the Wireless Button again to exit.
    0