Bias Amp 2 Standalone doesn't save sound settings
I find that the audio settings in Bias Amp 2 standalone don't get saved.
I start it up, set my audio settings to my soundcard and it works fine. Next time I start the software, I have to set them again.
Is it possible this might be because I'm running as a user without administrator privileges and it's trying to save the settings and fails because it would need these privileges?
I'm on the latest Win10 x64
A Former User last edited by A Former User
It should pick whatever is active in the System. If you're starting it before turning on your interface, it's likely going to need prompting. My DAW does.
Good point, but that's not it. Soundcard is already on.
I can start Bias Amp, set the soundcard, close it and open it again and I have to set it again. :(
I tried running it with Admin privileges but the same thing happens. I would guess it's a bug...
Anthony Newcomb last edited by
@cz Have you opened a support ticket yet?
Haven't yet. Just wanted to check first whether I was the only one. I also think it only appeared in the last version, so I guess I was holding out whether the next one might fix it :)
(Off to the Ticket office)
cjunkins last edited by
I am currently in the same boat as the Thread Starter. I have an open ticket, and am working with one of their tech's currently. Just waiting on the tech to get ahold of a 2i2 2nd gen as well for testing purposes.
stormyandcold last edited by
I can confirm this bug exists with Windows 10 Pro 64bit build 17331.1
I'm using a Focusrite 18i20 1st gen. However, the bug still happens with an RME Babyface. Both Bias AMP 1 and Bias FX don't have this problem.