Bias Amp 2 Standalone doesn't save sound settings
-
Hi,
I find that the audio settings in Bias Amp 2 standalone don't get saved.
I start it up, set my audio settings to my soundcard and it works fine. Next time I start the software, I have to set them again.Is it possible this might be because I'm running as a user without administrator privileges and it's trying to save the settings and fails because it would need these privileges?
I'm on the latest Win10 x64
Thanks!
-
It should pick whatever is active in the System. If you're starting it before turning on your interface, it's likely going to need prompting. My DAW does.
-
Good point, but that's not it. Soundcard is already on.
I can start Bias Amp, set the soundcard, close it and open it again and I have to set it again. :(I tried running it with Admin privileges but the same thing happens. I would guess it's a bug...
-
@cz Have you opened a support ticket yet?
-
Haven't yet. Just wanted to check first whether I was the only one. I also think it only appeared in the last version, so I guess I was holding out whether the next one might fix it :)
(Off to the Ticket office)
-
I am currently in the same boat as the Thread Starter. I have an open ticket, and am working with one of their tech's currently. Just waiting on the tech to get ahold of a 2i2 2nd gen as well for testing purposes.
-
I can confirm this bug exists with Windows 10 Pro 64bit build 17331.1
I'm using a Focusrite 18i20 1st gen. However, the bug still happens with an RME Babyface. Both Bias AMP 1 and Bias FX don't have this problem.