Navigation

    • Login
    • Search
    • PositiveGrid.com
    • Help Center
    • Contact Support

    Interfacing Spark Amp with a PA Mixer to External Speaker

    Spark
    3
    3
    6515
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • ledbazooka
      ledbazooka last edited by ledbazooka

      I just ran my spark amp through a Yamaha MG12 PA Mixer to a powered speaker Mackie Thump 1000 watt Monotor. And it Sounds really amazing.

      Directions:
      What you need to do is run a wire splitter from the headfones input on the spark amp out into the input of the mixing board via RCA cables to the Mixing board inputs. You achieve this with a splitter cable y cable, the small jack end gets plugged into the spark amp headfones jack input on top of the spark amp, and the two RCA cables out from the splitter go direcrly into the stereo input of the mixing board. You then run a speaker wire from your mixing board input to a powered speaker. You then plug your guitar jack into the spark amplifier input jack. And there you go. It's simple.

      arinconc 1 Reply Last reply Reply Quote 0
      • arinconc
        arinconc @ledbazooka last edited by

        @ledbazooka
        Could you send any image or video? It would help a lot. Millions of thanks

        mig 1 Reply Last reply Reply Quote 0
        • mig
          mig @arinconc last edited by

          @arinconc I think this is what the cable(s) are and setup. Depending on your mixer, you could use either an adapter cable with a stereo 1/8" mini plug from the headphone out to split RCA plugs or 1/4" phone plugs at the other end for the mixer or amp or recording device.
          alt text

          1 Reply Last reply Reply Quote 0
          • 1 / 1
          • First post
            Last post