Navigation

    • Login
    • Search
    • PositiveGrid.com
    • Help Center
    • Contact Support

    Adding an effect to my current effect/amp setup

    Spark
    2
    2
    267
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • ben_goldberg
      ben_goldberg last edited by

      How do I choose an additional effect to add to a given loop? I was under the impression that there were hundreds of effects that I could add to any current effect/amp setup.

      dhbailey 1 Reply Last reply Reply Quote 0
      • dhbailey
        dhbailey @ben_goldberg last edited by

        @ben_goldberg There are lots of effects but not hundreds of them. And each type of effect is fixed in its place in the chain. The chain is:
        noisegate-compressor-drive-amp-modulation-delay-reverb

        We can't change that order and we can't add any at the beginning, the middle or the end, but within each type of effect other than noise gate there are different effects of the same type that we can choose among, each one having the ability to have its own settings.

        Submitting a feature request through the Contact Support link at the top of this page is the best way to get any ideas you might have about the ability to change the sequence of effects and amp, the types of effects that should be offered, etc.

        1 Reply Last reply Reply Quote 0
        • 1 / 1
        • First post
          Last post