Getting Studio one 4 to recognize my spark amp



  • Having a hard time to get either my computer or the studio one to recognize my spark amp as an input using the usb cable. My computer only lists "Usb audio CODEC" as its only input selection.

    Thanks in advance

    Jim



  • Found your patch installed it and it alternates between USB Spark 40 and USB audio codec....when i try to make it default its just keeps flipping back and forth in windows input setup I am trying to keep my monitors as out put as well.....thanks for being attentive. Jim



  • I got past this it took some time for me to get this to work with my computer.



  • @stiches4u How did you do it????



  • I had some issues getting the audio device to show up on my mac the other day. I think I had to power it up and then connect it to USB. I also have two USB hubs and for some reason audio interfaces are picky. My Focusrite solo won't show up on one and the Spark would only work on the other. If you have a hub its worth trying direct usb to computer I think.



  • @stiches4u

    I got Studio One to recognize my Spark and I made sure to select 48 kHz sample rate and when I go to make new track, I get this horrible noise. And on top of that when I strum my guitar, nothing shows up in the monitoring section for audio. I hope someone figured this out and posts it as I am totally stuck.



  • @gtrboy77 said in Getting Studio one 4 to recognize my spark amp:

    @stiches4u

    I got Studio One to recognize my Spark and I made sure to select 48 kHz sample rate and when I go to make new track, I get this horrible noise. And on top of that when I strum my guitar, nothing shows up in the monitoring section for audio. I hope someone figured this out and posts it as I am totally stuck.

    I have the exact same issue...