The Reaper pre-render tone contrast
Tannhauser last edited by Tannhauser
I should probably post this over there, though I'm curious to see your response.
Pre-render tone was recorded into Audacity from the main output, while recording the stem in Reaper and then rendering. Post-render was brought over, and both were upped to -2db with the 'amplify' effect. Pre-render sounded and looked quieter, so I upped to -1db. (I can imagine you all will like the pre-render tone over the post render tone, but that's another discussion.) It sounds like the power amp modeling of 2.0 isn't being used, or the 2.0 cab algorithm isn't. Perhaps a midi thing is happening that turns something off.....
Not good! What happens if you try and null the rendered signal with the live one? If it bounces up and down then yeah, its part of the dynamic circuit. SO far my renders from Bias FX have been good, but they are all Bias 1 amps
Tannhauser last edited by
@pipelineaudio : what do you mean by null?
Play the rendered file lined up with the live file, flip the phase switch on one of them. It should 100% cancel out