Adjusting preset volume
-
Do anyone know how to adjust the preset volume in bias amp? I found such a good Mesa Stiletto tone in the tonecloud, but it‘s too quit. Adjusting the Master isn‘t enough. Only when I take another cab sim it gets as loud as my other presets. But this changes the sound... Is there a way to encrease the volume of a preset without changing the sound?
-
I request an amp level that was independent of master but it has never been implemented. In amp, I use the EQ's level or the mic level control in the cab sim.
-
It's here under the transformer setting. It increases the volume independently to the output knob on the rack/head, or output slider in the program. Hope that helps!
-
Yes! That‘s it! Thank you guys!
-
I do it by setting the impulse level
-
@pipelineaudio : that has a bit less gain increase than the peq.
@Liam : I was messing around with that a while ago, and wasn't sure whether the sound changed.....
-
@tannhauser I've used it to adjust the volume of a few of my amp models and not noticed any tone change but ymmv. I was trying it through the head into a guitar cab which may mask any changes if they're subtle
-
Maybe @felix or @Joe-Kuo could confirm with engineering department whether or not that knob is a straight up linear level control or whether it affects the transformer tonality ala an amp master volume, etc.
-
@liam : if you aren't noticing a difference, there probably isn't any, which suggests the Output post everything. And makes me wonder what conditions the stock amp settings are being set up in.
